Filter
Top Products
75
Safety and Security
Occupant safety
2 Hook
3 Anchorage ring
̈ Securely fasten hook 2, which is part
of the tether strap, to anchorage
ring 3.
Once the top tether anchorage hook is at-
tached, the child restraint itself can be se-
cured. Tighten the top tether strap
according to the child restraint manufac-
turer’s instructions.
̈ Reinstall cover after removing the
tether strap.
Child seat anchors – LATCH type
This vehicle is equipped with two LATCH
(L
ower Anchors and Tethers for CHildren)
type anchors (at each of the rear seats) for
the installation of a LATCH child seat with
the matching anchor fittings.
If you have not installed a child seat, the
LATCH anchor are covered with an uphol-
stery blend.
1 Indicates the position of the anchors
2 Anchors
3 Upholstery blend
4 Installation device
i
For safety reasons, make sure hook 2
has attached to ring 3 beyond the
safety catch, as illustrated.
Warning! G
Vehicles with adjustable rear seats/bench*:
Never adjust the rear seat position after in-
stalling the child restraint. Adjusting the rear
seat position after installing the child re-
straint could damage the child restraint
and/or introduce undesirable slack into the
webbing and loosen or misposition the child
restraint, lessening the effectiveness of the
child restraint and thus increasing the
chance or severity of injury in an accident.
୴୴