Filter
Top Products
298
Controls in detail
Useful features
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Step 3:
̈ Hold the end of the hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or 4) to be pro-
grammed, while keeping the indicator
lamp 1 in view.
Step 4:
̈ Using both hands, simultaneously
press the hand-held remote control
button 6 and the desired signal trans-
mitter button (2, 3 or 4). Do not
release the buttons until step 5 is com-
pleted.
The indicator lamp 1 will flash, first
slowly and then rapidly.
Step 5:
̈ After the indicator lamp 1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.
Step 6:
̈ Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe the indicator lamp 1.
If the indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or 4) is pressed and re-
leased.
i
The indicator lamp 1 flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
୴୴