Filter
Top Products
157
Controls in detail
Control system
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
୴ page 127).
Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
position U, the following lamps will
switch on during darkness when the vehi-
cle is unlocked with the SmartKey:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
ț Front fog lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey, the lamps
will switch off automatically after approxi-
mately 40 seconds.
To activate locator lighting:
̈ Make sure the function surround light-
ing is set to
on
, see (୴ page 157).
̈ Move the selection marker with
button æ or ç to the
Lighting
submenu.
̈ Press button j or k repeatedly
until the message
Function Surround
lighting
appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press button æ or ç to switch
the locator lighting function
On
.
̈ Turn the exterior lamp switch to
position U when exiting the vehicle
(
୴ page 127).
The locator lighting feature is
activated.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting
submenu to factory settings
(
୴ page 149) while driving will not
deactivate the daytime running lamp
mode.
The following message appears in the
multifunction display:
Lighting – Cannot be completely
reset to factory settings while
driving
.