Filter
Top Products
146
Controls in detail
Control system
Operate the CD player
̈ Turn on the radio and select CD
(
୴ page 227). Vehicles with
COMAND*: Refer to separate
operating instructions.
̈ Press button è or ÿ repeatedly
until the settings for the CD currently
being played appear in the multifunc-
tion display.
1 Current CD (for CD changer*)
2 Current track
̈ Press button k or j repeatedly
until the desired track is selected.
NAV* menu
The
Nav
menu contains the functions
needed to operate your navigation system.
̈ Press button è or ÿ repeatedly
until the message
Nav
appears in the
multifunction display.
ț If COMAND* is switched off, the mes-
sage
Nav off
appears in the multifunc-
tion display.
ț With COMAND* switched on but route
guidance not activated, the direction of
travel and, if available, the name of the
street currently traveld on appear in
the multifunction display.
ț With COMAND* switched on and route
guidance activated, the direction of
travel and maneuver instructions ap-
pear in the multifunction display.
Please refer to the COMAND* manual for
instructions on how to activate the route
guidance system*.
Vehicle status message memory menu
Use the vehicle status message memory
menu to scan malfunction and warning
messages that may be stored in the
system. Such messages appear in the
multifunction display and are based on
conditions or system status the vehicle’s
system has recorded.
The vehicle status message memory menu
only appears if there are any messages
stored.
i
For more information on satellite radio
operation, see “Introduction to satellite
radio* (USA only)” (
୴ page 222).
Vehicles with COMAND*: Refer to
separate operating instructions.
i
To select a CD from the magazine,
press a number on the audio system or
the COMAND* system key pad located
in the center dashboard.