Filter
Top Products
258
Controls in detail
Soft top
̈ Press the soft top switch as indicated
by the arrow 1 until the soft top is
completely closed and locked.
During the closing procedure the multi-
function display shows the message
Top in operation
.
If the soft top is closed and locked, the
multifunction display will briefly show
the message
Top closed
.
If you continuously press on the soft
top switch the windows will close.
However, the windows can also be
closed/opened later on, for more informa-
tion see “Opening and closing all side win-
dows with the soft top switch”
(
୴ page 254) or see “Opening and closing
the windows” (
୴ page 249).
i
For safety reasons, the soft top cannot
be closed while driving.
i
The soft top cannot be closed using the
soft top switch when the roll bars have
been released. The roll bars need to be
lowered before the soft top can be op-
erated again using the soft top switch.
If the roll bars have released and the
soft top is open, you can lower the roll
bars manually (
୴ page 424) or contact
an authorized Mercedes-Benz Center
to have the roll bars lowered.
Warning! G
To prevent possible accidents, drive the ve-
hicle only with the soft top either completely
closed and locked, or fully lowered into its
storage compartment.
If the soft top does not completely open or
close, a warning sounds. In the multifunc-
tion display you will see K, and the mes-
sage
Top being lowered
appears. After
about 15 seconds the roof hydraulics lose
pressure.
Properly lock the soft top (
୴ page 259) be-
fore continuing to drive.