Filter
Top Products
216
Controls in detail
Power windows
Fully opening the windows
(Express-open)
̈ Press switch 2 to 5 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Pull switch 2 to 5 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
Stopping windows during Express-op-
eration
̈ Press or pull the respective power win-
dow switch again.
Synchronizing power windows
The power windows must be synchronized
ț after the battery has been disconnect-
ed
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing
̈ Close all doors.
̈ Switch on the ignition (୴ page 36).
̈ Pull switch 2 to 5 until the side win-
dows are completely closed.
̈ Hold on to switches 2 to 5 for
approximately 1 second.
The power windows are synchronized.
Warning! G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.
!
If the upward movement of the window
is blocked during the closing proce-
dure, the window will stop and open
slightly.
Remove the obstruction, pull the re-
spective power window switch again
past the resistance point and release.
If the window still does not close when
there is no obstruction, pull and hold
the respective power window switch.
The side window will then close without
the obstruction sensor function.