Filter
Top Products
210
Controls in detail
Useful features
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion of
this text. (A second person may make the
following training procedures quicker and
easier.)
̈ Locate training button on the garage
door opener motor head unit.
Exact location and color of the button may
vary by garage door opener brand. If there
is difficulty locating the transmitting but-
ton, refer to garage door opener Opera-
tor’s Manual.
̈ Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds time to initiate the
following step.
̈ Firmly press and release the pro-
grammed integrated remote control
transmit button.
̈ Press and release same button a sec-
ond time to complete the training pro-
cess.
Some garage door openers may require
you to do this procedure a third time to
complete the training.
̈ Confirm the garage door operation by
pressing the programmed button on
the integrated remote control transmit-
ter.
Canadian programming
During programming, your hand-held
transmitter may automatically stop trans-
mitting.
̈ Continue to press and hold the inte-
grated remote control transmitter but-
ton (refer to step two through four in
the “Programming” portion) while you
press and re-press (“cycle”) your
hand-held transmitter every two sec-
onds until the frequency signal has
been learned.
Upon successful training, the indicator
lamp will flash slowly and then rapidly
after several seconds.