Filter
Top Products
104
Controls in detail
Lighting
USA only:
The high beam headlamps can also be ac-
tivated when driving with the daytime run-
ning lamp mode activated and the exterior
lamp switch in position
M.
To activate the daytime running lamp
mode, see “Setting daytime running lamp
mode (USA only)” (
୴ page 124).
Locator lighting and night security
illumination
Locator lighting and night security illumi-
nation are described in the control system
section, see “Setting locator lighting”
(
୴ page 125) and "Exterior lamps delayed
switch-off" (
୴ page 125).
Switching on front fog lamps
̈ Make sure that the low beam head-
lamps are switched on.
̈ Pull out exterior lamp switch to first
stop.
The green indicator lamp
‡ in the
lamp switch lights up.
Switching on rear fog lamp
̈ Make sure that the low beam head-
lamps are switched on.
̈ Pull out exterior lamp switch to second
stop.
The yellow indicator lamp
† in the
lamp switch lights up.
Combination switch
The combination switch is located on the
left side of the steering column.
1 High beam
2 High beam flasher
Switching on high beams
̈ Turn the exterior lamp switch to B
or to
U (୴ page 102).
̈ Push the combination switch in
direction 1.
The high beam symbol in the tachome-
ter will light up.
i
See notes on the exterior lamp switch
(
୴ page 102).