Black plate (56,1)
6. Fold the trunk board into the position
shown in the figure.
7. Latch the hook onto the anchor
bracket, and tighten the tether strap
following the child-restraint system
manufacturer's instructions.
8. Push the trunk board down to its
original position.
WARNING
Use the tether and tether anchor only
for a child-restraint system:
Using the tether or tether anchor to
secure anything but a child-restraint
system is dangerous. This could
weaken or damage the tether or tether
anchor and result in injury.
Always route the tether strap for the
center-rear seat position to the correct
tether anchor position:
Routing the tether strap for the center-
rear seat position to one of the other
tether anchor positions on the
outboard seatbacks is dangerous. In a
collision, the tether strap could slide
and loosen the child-restraint system.
The child-restraint system could move
which may result in death or injury to
the child.
2-44
Essential SafetyEquipment
Child Restraint
CX-7_8V28-EA-06B_Edition2 Page56
Monday, March 13 2006 5:5 PM
Form No.8V28-EA-06B