Filter
Top Products
Black plate (122,1)
To stop sliding partway, push any part of
the tilt or slide switch.
Close
Close
Open
Re-initializing
If the battery had been disconnected
during vehicle maintenance or for other
reasons, the moonroof may not fully open
or close. The moonroof's jam-safe
function does not function while the
moonroof is initializing. Carry out the
following procedure to resume operation:
1. Turn the ignition switch to the ON
position.
2. Push the rear of the tilt switch, to
partially tilt open the rear of the
moonroof.
NOTE
If the re-initialization procedure is
performed while the moonroof is in the
slide position (partially open) it closes
before the rear tilts opens.
3. Repeat the procedure in Step 2. The
rear of the moonroof tilts open to the
fully open position, then closes a little.
qEngine-off Moonroof Operation
The moonroof can be operated for about
40 seconds after the ignition switch is
turned from the ON position to the ACC
or LOCK position with all doors closed. If
any door is opened, the moonroof will be
inoperable.
NOTE
For engine-off operation of the
moonroof, the switch must be pushed
firmly throughout moonroof closure
because the auto-closing function will
be inoperable.
qOpening/Closing the Moonroof
from Outside
The moonroof can be opened or closed
from outside the vehicle after the doors
and the liftgate are closed.
WARNING
Make sure the opening is clear before
closing the moonroof:
Closing the moonroof is dangerous. A
person's hands, head, or even neck
could be caught by the moonroof and
result in serious injury or even death.
This warning applies especially to
children and pets.
3-46
Knowing YourMazda
Doors and Locks
CX-7_8V28-EA-06B_Edition2 Page122
Monday, March 13 2006 5:5 PM
Form No.8V28-EA-06B