Filter
Top Products
10
Getting started
Activation
Insert the map disc into the unit to start the Mobile Navigation System.
Note
●
The map disc cannot be inserted or ejected while the ignition switch is in the OFF position.
●
Remember that the battery can run down if the ignition switch is kept in the ON or ACC
position for a long time while the engine not running.
■
Map Disc
●
Refer to “Handling and Care of Map Discs” to know how to handle a map
disc (
page 53).
1
Turn the ignition switch
to the ON position and
press
to open
the display.
Note
●
This display angle can be adjusted by pressing .
When the is
pressed, the display
angle changes in
stages.
●
Press to close the display.
2
Insert the map disc
with the printed side
facing up.
Note
●
The main unit is located in the glove box
compartment.
●
Condensation may form on the optical lens or the
map disc inside the unit when the temperature in
the vehicle increases in a short time such as when
heating the car on a cold day. This condensation
may cause malfunctions. If so, unload the map disc
and do not operate the unit for approximately 1
hour. Wipe the condensation off the map disc with a
soft cloth.
If the unit does not operate correctly after 1 hour,
consult an Authorized Mazda Dealer.
Cautions
OPEN
TILT
TILT
OPEN
[CAUTION] screen
MAZDA3_Navi_EA.book Page 10 Monday, June 6, 2005 9:39 AM