Filter
Top Products
This wire will become grounded when the alarm is in a armed state. This wire can be connected to an optional starter /
ignition disable relay - ECU disable relay, fuel pump disable relay or it can be used to activate other functions of the
vehicle such as window roll-up. The connection of an additional relay may be necessary
This wire can be used to activate the
existing vehicle’s horn as the alarm
system’s optional warning audible
device. It’s a 200mA transistorized
low current output, and should only
be connected to the low current
ground output from the vehicle’s
horn switch/relay. When the alarm is
triggered, the horn will sound
(depending on the vehicle’s
requirement an additional relay may
be required as shown).
87
87a
86
85
30
+12V
To Horn
+12V or Ground
Depending on System
Requirements
Fuse
Light Brown
Wire
White 6-Pin
Connector
Wiring (continued)
15
Orange/White Wire: (-) 500mA Grounded Output when Armed
HC6 White 6-Pin Connector
(continued)
Light Brown Wire: (-) Horn Output
Orange Wire
White 20-Pin
Connector
87
87a
86
85
30
"ACC" "START"
"OFF" "IGN"
Cut BlackBlack
Starter
Plug-In Harnesses
P2 Valet Switch
P1 Status LED Indicator