Filter
Top Products
32
Destination Pointer does not point to the destination:
1. Note that much of the navigation information is
based upon your movement. If you are standing still
the navigation information (destination pointer, etc.)
is not updated until you are moving. (The receiver is
unable to detect which way you are facing while you
are stationary.)
Position coordinates on your receiver do not match the
location on your map.
1. Make sure that your receiver is set up to use the same
datum as your map. The map datum is generally shown
in the map legend. See Map Datum under Setup for
instructions on selecting the map datum in your receiver.
2. Check your LAT/LON format. Make sure that the for-
mat selected in COORDINATE SYSTEM (DEG/
MIN/SEC or DEG/MIN.MM) is in the same format
as the map you are using.
Commonly Asked Questions
Does the receiver adjust itself for daylight savings time?
No. You need to reset the time for changes in your area.
(See “Changing Time Display and Time” on page 28.)
Will my receiver function correctly in the year 2000?
Absolutely. Even though only the last two digits of the
year are displayed, the full year designator is stored in
memory.