Filter
Top Products
LOWRANCE
192 kHz TRANSDUCER
POWER TO SAM-50HPD
(NOT INCLUDED)
CONNECTORS
The diagram above shows the three connectors on the back of the sonar
unit. Looking at the back of the unit, the 192 kHz transducer connector is
at the far left. Plug the 192 kHz transducer in here. The center connector
is for the power cable. The connector at the far right is for a serial cable that
is included with the SAM-50HPD. This is the cable that allows the SAM to
communicate with the sonar unit. See the SAM-50HPD's installation
manual for more information.