Filter
Top Products
TRANSDUCER INSTALLATION - 8° Transducer Only
The 8° transducer is designed for transom mount only. It can be installed
on any outboard or stern-drive powered boat. Do not use this transduc-
ers on an inboard powered boat.
Please read these instructions carefully before installing your trans-
ducer. The transducer mounting location is the most critical part of a
sonar installation. If it isn’t done properly, the sonar can’t perform to its
potential.
ASSEMBLY
1. Locate the four ratchets in the transducer's hardware package. Note
there are letters engraved into one side of each ratchet. These are for
the coarse angle adjustment. A standard transom angle is 14 de-
grees. By aligning a letter on the ratchet to the alignment mark on the
the transducer bracket, the correct transducer angle can be attained.
Once you've determined the correct angle, press one ratchet on each
side of the transducer and one ratchet on each transducer bracket as
shown below.
ALIGNMENT
MARKS
TRANSDUCER
TRANSDUCER
BRACKET
ALIGNMENT
LETTERS
RATCHET
A
B
C
D
E
F
A
B
C
D
E
F