Filter
Top Products
2. Once you've determined the proper ratchet placement, assemble the
transducer and bracket as shown above. Don't tighten the nut at this
time.
INSTALLATION - Location
1. The transducer must be placed in a location that has a smooth flow of
water at all times. Air bubbles created by the movement of the boat
hull against the water interfere with the sonar signal. This causes
“noise” or random marks to appear on the sonar’s display. You may
need to carefully view the water’s path at the transom while the boat
is moving to determine the best location for the transducer.
2. Make certain the chosen location doesn’t interfere with the boat’s
trailer. Mount the transducer at least one foot from the engine’s lower
unit. This will prevent air bubbles from the transducer interfering with
the propeller.
CAUTION!
CLAMP THE TRANSDUCER CABLE TO
TRANSOM NEAR THE TRANSDUCER. THIS
WILL HELP PREVENT THE TRANSDUCER
FROM ENTERING THE BOAT IF IT IS
KNOCKED OFF AT HIGH SPEED.
GOOD LOCATION
BOLT
FLAT
WASHER
FLAT
WASHER
LOCK
WASHER
NUT