Filter
Top Products
TRANSDUCER LOCATION
(HIGH SPEED)
TRANSDUCER LOCATION
(TROLLING SPEED)
2. Follow the instructions on the epoxy package and mix it thoroughly.
Do not mix it too fast, as it will cause bubbles to form in the epoxy.
Apply a small amount on the face of the transducer as shown above,
then spread a small amount onto the sanded area on the hull. Place the
transducer into the epoxy, twisting and turning it to force any air bubbles
out from under the transducer face. The face of the transducer should be
parallel with the hull, with a minimum amount of epoxy between the hull
and transducer. After the epoxy dries, route the cable to the sonar unit.
SAND THIS SURFACE
SPREAD EPOXY HERE
Shoot-thru-hull Installation
(20° Transducer Only)
1. Make certain the area is clean, dry, and free of oil or grease, then
sand both the inside surface of the hull and the face of the transducer
with 100 grit sandpaper. The surface of the hull must be flat so the entire
transducer face is in contact with the hull prior to bonding.