Filter
Top Products
14
3. Hold unit upright in left hand. Use a thumbnail or fingernail to grab
the groove in the bottom of the MMC.
4. Drag the MMC from the slot into the battery compartment.
5. Hold AirMap face up and give it a shake to dump the MMC into your
hand or onto a work surface.
To add an MMC or SD Card
1. Remove battery compartment cover.
2. Remove batteries, if present.
3. Hold unit upside down in left hand. Grasp the bottom corner of the
MMC with your other hand. The MMC label should be toward you.
4. Use the white lines and text on the circuit board as a guide and drop
the MMC into the slot.
5. Gently shake the unit or use your finger to nudge the MMC into verti-
cal alignment. Then, gently push the card into the slot with your finger.
6. Replace the batteries and battery cover.
Aquabag Waterproof Travel Pouch Installation
The waterproof travel pouch keeps your GPS dry when the going gets
wet. An adjustable neck strap on the pouch keeps your unit within
reach. The pouch is made of a transparent material that is rugged, yet
easy to see through. The pouch is flexible enough for you to operate the
AirMap's keys with the unit inside. To use it, open the closure flap and
unroll the anti-moisture baffle to open the bag. Slip the unit inside. Roll
up the baffle and close the outer flap.
Insert AirMap into bag upside down, left. That makes it easier to read
when wearing the unit around your neck, right.