Filter
Top Products
8
8. Secure the cable near the scanner to support the weight of the cable
and prevent strain on the watertight cable seal. If the cable is to pass
through tubing or a bulkhead, protect the unfinished end. Do not use
the unfinished wires or fabric braid to pull the cable. Attach a fish cord
only to the cable jacket.
9. Route the cable to the RIM 200, securing it at appropriate points
along the way. Make a drip loop and apply sealant at the entry point of
an exterior bulkhead.
Connecting Radar Antenna to Power Source
The following instructions show how to connect radar radome (LRA
1000, LRA 1500 and LRA 2000) and open array (LRA 4000 and LRA
5000) antennas to a power source.
To connect LRA 1000, LRA 1500 and LRA 2000 radome antennas to power:
Antenna large White wire (+) to radar motor power positive
Antenna large Black wire (–) to radar motor power negative
Caution:
If you have a LRA 1000 or LRA 1500, fuse the radar unit's large
White wire (+) with the supplied 5-amp fuse. If your unit is a LRA
2000, fuse the radar unit's large White wire (+) with the supplied 8-
amp fuse.
To connect LRA 4000 and LRA 5000 array antennas to power:
Antenna large Red wire (+) to magnetron power positive
Antenna large Black wire (–) to magnetron power negative
Antenna large White wire to radar motor power positive
Antenna large Blue wire (–) to radar motor power negative
Caution:
Fuse both the radar unit's large Red wire (+) and large White
wire (+) with the supplied 8-amp fuses.