Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 54
Adjusting chain tension - fitting rear wheel
400225-11
ದ Loosen nutsb.
ದ Adjust the chain tension by turning the adjusting screwsb
left and right.
Specification
Chain tension 8… 10bmm (0.31… 0.39bin)
Turn the adjusting screwsb
left and right so that the markings on the left and
right chain adjusters are in the same position relative to the reference marksb
.
The rear wheel is then correctly aligned.
ದ Tighten nutsb
.
Adjusting chain guidebx
400252-10
ದ Remove screwsb andb. Take off the chain guide.
Conditions
Number of teeth: ืb44bteeth
ದ Insert nutb
in holeb. Position the chain guide.
ದ Mount and tighten screwsb
andb.
Specification
Remaining screws, chassis M6 10bNm
(7.4blbfbft)
Conditions
Number of teeth: ุb45bteeth
ದ Insert nutb
in holeb. Position the chain guide.
ದ Mount and tighten screwsb
andb.
Specification
Remaining screws, chassis M6 10bNm
(7.4blbfbft)
Brake fluid reservoir
Warning
Danger of accidentsಘBrake system failure.
ದ If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
The brake fluid reservoirs of the front and rear brakes are dimensioned so that they do not need topping up with brake fluid even if the
brake linings are worn.