KTM 530 EXC-R USA Motorcycle User Manual


 
CC
00AA
AA
22
11
MAINTENANCE WORK ON CHASSIS AND ENGINE
35

Checking the riding sag of the shock absorber
400222-10
Measure distanceb of rear wheel unloaded. ( P. 34)
With another person holding the motorcycle, sit on the saddle with full protective
clothing in a normal sitting position (feet on footrests) and bounce up and down a
few times until the rear suspension levels out.
The other person now has to measure the distance between the rear axle and a
fixed point.
Make a note of the value as measurementb
.
Info
The riding sag is the difference between measurementsb andb.
Check the riding sag.
Riding sag 105bmm (4.13bin)
» If the riding sag differs from the specified measurement:
Adjust the riding sag. ( P. 36)

Adjusting spring preload of the shock absorberbx
Danger
Danger of accidentsThe shock absorber is under high pressure.
The shock absorber is filled with highly compressed nitrogen, so never dismantle the shock absorber or carry out any main-
tenance on it yourself.
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
Remove shock absorber. ( P. 36)
After removing the shock absorber, clean it thoroughly.
400216-10
Loosen screwb.
Turn adjusting ringb
until the spring is no longer under tension.
Combination wrench (50329080000)
Hook wrench (T106S)
Measure the overall spring length when not under tension.
Tighten the spring by turning adjusting ringb
to measurementb.
Specification
Spring preload
Standard 9bmm
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
Tighten screwb
.
Specification
Screw, shock absorber adjusting ring M6 5bNm (3.7blbfbft)
Installing shock absorber. ( P. 36)