Filter
Top Products
0022
0011
0022
0011
00
33
00
22
00
11
0044
0055
0066
0077
0088
0099
MAINTENANCE WORK ON CHASSIS AND ENGINE
48
Adjusting handlebar positionbx
400223-10
(EXC-RbEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-W)
ದ Remove the four screwsb
. Remove the handlebar clamp. Remove the handle-
bar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the two screwsb
. Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Place the handlebar support in the required position. Fit and tighten the two
screwsb
.
Specification
Screw, handlebar support M10 40bNm
(29.5blbfbft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
ದ Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
ದ Position the handlebar clamp. Fit and evenly tighten the four screwsb
.
Specification
Screw, handlebar clamp M8 20bNm
(14.8blbfbft)
Info
Make sure the gap width is even.
400343-10
(EXC-RbSIXbDAYS)
ದ Remove the four screwsb
. Remove the handlebar clampsb
with rubber wash-
ersb
and elastomersb
.
ದ Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the lower shellsb
.
ದ Remove the clamp barb
with the rubber conesb
.
ದ Remove the two screwsb
. Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.