Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 141
700313-01
– Remove bushing and bushing. Clean and grease the roll surfaces of the bushing
and the shaft seal rings.
Long-life grease ( S. 224)
– Fit the bushings.
– Clean the thread of the wheel spindle and nut.
– Clean the contact areas of the brake caliper support and swingarm.
700314-01
– Push the brake caliper support completely to the rear.
– Position the rear wheel, and position the brake caliper support between the rim and the
brake disc.
– Position the brake caliper on the brake disc.
– Position the rear wheel on the bearing surfaces in the swingarm.