Filter
Top Products
9.7
Section 9
Disassembly
9
Figure 9-23. Location of Four Screws Securing
Blocking Plates.
Remove Overflow Reservoir
1. Remove the reservoir cap from the reservoir.
2. Loosen the two screws holding the overflow
reservoir retainer bracket to the radiators. See
Figure 9-24.
3. Carefully lift the bracket up slightly to unhook the
locking tab, and remove the reservoir from under
the bracket. See Figure 9-25.
Figure 9-25. Removing the Reservoir.
Remove Ignition Modules
1. Rotate the flywheel to position one of the tapered
sections of the flywheel in line with one of the
ignition modules.
2. Remove the mounting screws securing the
ignition module. Access the inner screw
through the hole in the main support bracket.
See Figure 9-26.
Figure 9-24. Loosening Reservoir Bracket Screws.
Figure 9-26. Removing Inner Ignition Module
Mounting Screw.