Filter
Top Products
9.6
Section 9
Disassembly
4. Remove the throttle control bracket, governor
lever, and governor spring as an assembly. See
Figure 9-19.
Figure 9-19. Removing Main Bracket and Governor
Lever.
Remove Electric Starter
1. Disconnect the leads from the starter.
2. Remove the two starter motor mounting screws.
See Figure 9-20.
Figure 9-20. Removing the Starter Motor Mounting
Screws.
3. Remove the starter assembly from the adapter
plate.
Figure 9-21. Removing Adapter Plate Screws.
Remove Flywheel Fan and Blocking
Plates
1. Remove the four shoulder screws securing
the fan to the flywheel and remove the fan. See
Figure 9-22.
Figure 9-22. Removing Flywheel Fan.
2. Remove the four screws securing the R.H. and
L.H. blocking plates to the radiator supports and
take out the plates. See Figure 9-23.
4. Remove the two hex. flange screws and separate
the adapter plate from the crankcase. Note the
orientation of the notch on the bottom, toward the
dipstick. See Figure 9-21.