Kenwood DNX4250BT GPS Receiver User Manual


 
114114
Return to the Top page
Troubleshooting
Error Message Cause Solution
Disconnected
(iPod)
The iPod/Bluetooth audio player
is selected as a source although
no iPod/Bluetooth audio player is
connected.
Change the source to any source other than
iPod/Bluetooth. Connect an iPod/Bluetooth
audio player, and change the source to iPod/
Bluetooth again.
No Media file The connected USB device contains
no playable audio file. Media was
played that doesn’t have data
recorded that the unit can play.
See Playable Media and Files (P.116) and
try another USB device.
USB Device
Error!!
The connected USB device is rated
a current capacity higher than the
allowable limit.
Check the USB device. Some trouble may have
occurred to the connected USB device.
Change the source to any source other than
USB. Remove the USB device.
Authorization
Error
Connection to the iPod has failed.
• Remove the iPod and then reconnect it.
• The unit does not support the iPod.
See Connectable iPod/iPhone (P.118).
Update your
iPod
The iPod’s software is an older
version which the unit can not
support.
The unit may not support the connected iPod
model.
Confirm that the software for the iPod is the
latest version.
See Connectable iPod/iPhone (P.118).
Navigation
Error. Please
turn on power
again later.
The communication error has
occurred due to severely cold
temperature.
Turn on power again after warming your car
interior.
Antenna Error The antenna has a short-circuit and
the protective circuit has activated.
Check the Digital Radio antenna. If a passive
antenna without a booster is used, set Antenna
Power “OFF”.