Filter
Top Products
72 DNX9240BT/DDX8024BT/DDX8054BT
Navigation Setup
You can set Navigation parameters.
Display the Navigation Setup screen1
Touch [
] > [ ] > [Navigation]. (page 59)
Set each item2
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system. ( "Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
(
DNX9240BT: "25", DDX8024BT/
DDX8054BT: "21")
[Line Mute] Mutes the volume during voice
guidance of the navigation system.
(
"ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input] Selects a navigation
system connection. (
"RGB") (DDX8024BT/
DDX8054BT only)
"RGB": Allows the Kenwood’s Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUT1 port.
"OFF": Must be used if no navigation system
is connected. (The navigation display
is cancelled when the AV source is
switched.)
[On Screen Navigation] Sets an on-screen
display of the navigation screen. ( "OFF")
(DDX8024BT/ DDX8054BT only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
DSP Bypass Control
Temporarily bypassing DSP (Digital Signal
Processor) System.
Display the Audio SETUP screen1
Touch [ ] > [ ] > [Audio SETUP]. (page
59)
Set the DSP Select2
[Bypass] There is no effect by DSP.
[Through] There is an effect by DSP.
⁄
When the mode is set to [Bypass], DSP System cannot •
be adjusted.
Setup Menu