Kenwood DDX8024BT GPS Receiver User Manual


 
English 63
Security Setup
You can set a security code to protect your
receiver system against theft.
• When the Security Code function is activated, the code
cannot be changed and the function cannot be released.
Note the Security Code can be set as the 4 digit number
of your choice.
Display the Security screen1
Touch [
] > [ ] > [System] > [Security].
(page 59)
Setup the SI (Security Indicator)2
[Security Code Set] Displays the Security code
input screen.
[SI] Turns the SI function on or off.
If turned "ON", the SI indicator on the front
panel flashes when the vehicle ignition is off.
(
"ON")
Start Security Code setup3
If you have already completed the code registration,
[CLR] is displayed.
Enter a security Code4
Input four-digit number.
Register your security code5
Reenter the security code6
Reenter the same security code as that you have
entered in Step 4 for confirmation.
If you enter a different security code, the screen
returns to Step 4 (for the first code entry).
Register the security code again7
Now, your security code is registered.
If you have pressed the Reset button or if you
have disconnected the Receiver from battery...
Enter the correct security code1
You must enter the same security code as that
you have entered in Step 4.
Register your security code2
Now, you can use your Receiver.