Filter
Top Products
3 - 16
Scan Discard Partial Sequence to discard partial sequences when the
output sequence operation is terminated before completion. Scan Trans-
mit Partial Sequence to transmit partial sequences. (Any fields in the
sequence where no data match occurred will be skipped in the output.)
Require Output Sequence
When an output sequence is Required, all output data must conform to an
edited sequence or the engine will not transmit the output data to the host
device. When it’s On/Not Required, the engine will attempt to get the out-
put data to conform to an edited sequence but, if it cannot, the engine
transmits all output data to the host device as is.
When the output sequence is
Off
, the bar code data is output to the host as
the engine decodes it.
Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple
symbols with a single pull of the trigger. If you press and hold the trigger, aim-
ing at a series of symbols, it reads unique symbols once, beeping (if turned on)
Transmit Partial Sequence
* Discard Partial Sequence
Required
On/Not Required
*Off