Filter
Top Products
11 - 2
• The engine may not be programmed for the appropriate terminal interface.
For example, you scan “12345” and the host displays “@es%.”
Reprogram the engine with the correct Plug and Play or Terminal selection
bar code. See Chapter 2 and Chapter 3.
The engine may not be programmed to output your bar code data properly.
For example, you scan “12345” and the host displays “A12345B.”
Reprogram the engine with the proper symbology selections. See Chapter 6.
The engine won’t read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the engine reads
the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see Chapter 6).
2. If the engine still can’t read the sample bar codes, scan "All Symbologies" on
page 6-2.
If you aren’t sure what programming options have been set in the engine, or if
you want the factory default settings restored, scan Resetting the Factory
Defaults on page 1-7.