Filter
Top Products
GEM Owner’s Manual - Page 44
Operation and Maintenance
BASIC OPERATION
This is a basic list of how to operate the vehicle.
1. Make sure the disconnect switch is in the “ON” position.
2. Turn key switch on.
3. Fully release the parking brake.
4. Move direction switch to desired position.
5. Press accelerator pedal and go.
WHAT TO DO IN EMERGENCIES
Error Code Summary and Explanation
Error codes are used in the control system to indicate conditions that
prevent the vehicle from operating. All error codes are accompanied by the
service icon. The chart shown below summarizes the most frequent error
codes and remedies.
Error Code Condition Remedy
-11
Key on while pedal is pressed
Release accelerator pedal
-15 Low voltage on battery pack
-16 High voltage on battery pack
Turn lights on for several seconds, then
turn key switch on and off.
Need to charge batteries before operating
Pedal depressed and no direction
is selected.
Release pedal and insure direction switch
is “locked” into a position.
-06