Filter
Top Products
GEM Owner’s Manual - Page 41
Understanding the Features of Your Vehicle
The release handle is located at the rear of the vehicle between the
taillights.
To remove an installed Pak, or install a different one:
1. Empty Pak completely.
2. Steady the Pak to prevent it from falling.
3. Rotate the release handle clockwise to release the Pak.
4. Remove the Velcro safety strap.
5. Lift the empty Pak off the GEM.
6. Position the new Pak onto the brackets and apply the Velcro
safety strap.
7. Push forward to engage lock. Test to make sure Pak is secure.
This is a two stage locking system. If not secure, repeat
procedure.
The capacity of the Pak is not intended for any type of
passenger use. Doing so could result in personal injury.
WARNING!
Keep the Pak latch in a locked position when operating or
transporting the vehicle.
CAUTION!