Filter
Top Products
Setting Preset Stations
Up to 18 stations (six FM1, six FM2, and six AM)
can be programmed on the six numbered
pushbuttons, by performing the following steps:
1. Turn the radio on.
2. Press AM/FM to select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for longer than two seconds.
Ch will appear on the display when the station
has been set. Whenever that numbered
pushbutton is pressed, the station that was
set will return.
5. Repeat the Steps 1 through 4 for each
pushbutton.
Setting the Tone (Bass/Treble)
f
(Bass/Treble): Press this button until BAS
appears on the display. Then turn the volume knob
to increase or to decrease the bass. The display
will show the bass level.
Press this button until TRE appears on the
display. Then turn the volume knob to increase
or to decrease the treble. The display will show the
treble level. If a station is weak or noisy, decrease
the treble.
Adjusting the Speakers (Balance/Fade)
f
(Balance/Fade): To adjust the balance
between the right and the left speakers, press this
button until BAL appears on the display. Then turn
the volume knob to increase or to decrease the
balance between the right and the left speakers.
The display will show the balance level.
To adjust the fade between the front and the rear
speakers, press this button until FAD appears on
the display. Then turn the volume knob to increase
or to decrease the fade between the front and the
rear speakers. The display will show the fade level.
189