Filter
Top Products
AB
Receiver Status, EPE & DOP
Receiver status is indicated at the top of the page, with the current estimated
position error (EPE) and dilution of precision (DOP) to the left of the sky view.
DOP is an indication of satellite geometry quality measured on a scale of one to
ten (lowest numbers the best, highest numbers the poorest). EPE uses DOP and
other factors to calculate a horizontal position error in feet or meters. The status
field will show one of the following conditions:
Searching the Sky the receiver is looking for any satellites.
AutoLocate the receiver is is looking for any satellite whose almanac has been col-
lected. This process can take up to five minutes.
Acquiring Satellites the receiver is looking for and collecting data from satellites vis-
ible at its last known or initialized position, but has not collected enough data to cal-
culate fix.
2D Navigation at least three satellites with good geometry have been acquired and a
2 dimensional position fix (latitude and longitude) is being calculated. 2D Differential
Navigation will appear when you are receiving DGPS corrections in
2D mode.
3D Navigation at least four satellites with good geometry have been acquired and
your position is now being calculated in latitude, longitude and altitude. 3D
Differential Navigation will appear when you are receiving DGPS corrections in
3D mode.
Poor GPS Coverage the receiver is no longer tracking enough satellites for a 2D
or 3D fix.
Receiver Not Usable the receiver is unusable, possibly due to incorrect initialization
or abnormal satellite conditions. Turn the unit off and back on to reset.
Simulating Navigation the receiver is in simulator mode.
18
A. The status bar at the bottom of the page dis-
plays important status, alarm, and map scale
information. It also provides on-screen user
and message prompts.
B. The status bar will display an anchor symbol
or PRX icon whenever the anchor drag alarm
or proximity alarm has been triggered.
SECTION
1
SATELLITE PAGE
Receiver Status