Filter
Top Products
5. Use the Find Menu to select a route waypoint
from one of the Find Menu groups, and open
the information page for the selected waypoint,
city, exit, point of interest, and so on.
6. Highlight the Use button, and press Enter to
add it to the route.
7. To add more points to the route, repeat steps 4
to 6. You can rename the route if you want.
8. Highlight the Navigate button, and press Enter
to begin navigating.
Methods of navigating to a destination
• If you select the Go To button on the Waypoint
Page or other Find Menu items, the Vista Cx
creates a straight path (point-to-point) from
your current location to that location.
• If you select the
Navigate button on a Route
Page, the Vista Cx creates a route composed
of several user waypoints or Find Menu items,
with the last being your destination. It navigates
directly from point to point. Before each turn
in the route, a turn page shows a guidance
message and a graphic of the turn. You can
view the turns at any time by pressing up or
down on the Rocker while the route is active.
• Both navigation methods change when you
select the Follow Roads option on the Routing
Setup Page. Both Go To navigation and point-
to-point routing become routes that allow you
to navigate using roads.
The routes use existing roadways (either those
in the basemap or from downloaded detail
mapping) to automatically calculate a route to
your destination. Turns on roadways are added
to the Active Route Page and are preceded by a
guidance message with a graphic of the turn. If
there are not enough roads at your location to
calculate a route, a message appears.
Navigating a Route
After you create a route, you can begin navigation
immediately or save it to the Saved Routes list.
To navigate a saved route:
1. Press the Menu key twice to open the Main
Menu.
eTrex Vista Cx Owner’s Manual 33
BASIC OPERATION > CREATING AND USING ROUTES