Filter
Top Products
GPSMAP 5000 Series Owner’s Manual 39
Conguring the Device
ConfiGUrinG
the deViCe
Setting Alarms
You can set the chartplotter to sound an audible alarm when certain conditions are met. By default,
all alarms are turned off.
To set an alarm:
1. From the Home screen, touch Congure > Alarms.
2. Touch an alarm category.
3. Touch On to turn the alarm on and then use the touch screen keyboard to specify alarm
information.
Setting Navigation Alarms
From the Home screen, touch Congure > Alarms > Navigation.
Arrival
—set an alarm to sound when you are within a specied distance or time from a turn or
destination waypoint.
Type
—select whether you want arrival alarms to sound only when nearing destinations or when
nearing turns and destinations. Set to Off to disable arrival alarms.
Activation
—select whether the arrival alarm triggers based on time to arrival or based on
distance to arrival.
Change Time/Change Distance
—if you have Activation set to Time, touch Change Time to set
the number of minutes before arrival that the alarm should sound. If you have Activation set to
Distance, touch Change Distance to set the distance before arrival that the alarm should sound.
Use the on-screen keyboard to change the time or distance.
Anchor Drag
—sets an alarm to sound when you exceed a specied drift distance.
Off Course
—sets an alarm to sound when you are off course by a specied distance.
Setting System Alarms
From the Home screen, touch Congure > Alarms > System.
Clock—sets an alarm using the system (GPS) clock. The chartplotter must be on for the clock alarm
to work.
Battery—sets an alarm to sound when the battery reaches a specied low voltage.
GPS Accuracy
—sets an alarm to sound when the GPS location accuracy falls outside the user-
determined value.
Setting Sonar Alarms
NOTE: You must have an optional sonar module and a transducer connected using NMEA 0183 or the
Garmin Marine Network to receive sonar information.
From the Home screen, touch Congure > Alarms > Sonar.
Shallow Water—set an alarm to sound when the depth is less than the specied value.
Deep Water—set an alarm to sound when the depth is greater than the specied value.
Water Temp
—sets an alarm to sound when the transducer reports a temperature that is 2°F (1.1°C)
above or below the specied temperature.
•
•
•