Garmin 198C GPS Receiver User Manual


 
56 GPSMAP 198C Sounder Owner’s Manual
MAIN MENU > ROUTES TAB
Edit on Map—allows you to review and modify the route shown
for each point (waypoint or map item) on a map page. Use the
pointer to insert a new route point on a route leg, review the
waypoint, or map item.
To edit the route on the map:
From the Route Review Page, press MENU, highlight
Edit on Map, and press ENTER.
To edit a route point:
Use the ROCKER to highlight a route waypoint, and press
MENU.
To review a route point:
Highlight the point, and press ENTER. Press ENTER again
when finished.
A menu of editing choices appear, with options for removing,
moving (user waypoints only), or adding turns to the beginning or
end of the route.
To remove a route waypoint:
Highlight the Remove option, and press ENTER.
To move a route waypoint:
1. Highlight the Move option, and press ENTER.
2. Move the pointer to the new map location, and press
ENTER.
To add turns at the beginning or end of the route:
1. Select the first (to add waypoints to the beginning of the
route) or last (to add waypoints to the end of the route)
route waypoint with the map pointer, and press MENU.
2. Highlight the Add option, and press ENTER.
3. Move the pointer to the new point or location, and press
ENTER.
4. If you are not inserting an existing waypoint, press ENTER
to confirm the new waypoint.
5. Repeat steps 3 and 4 to insert additional waypoints, or
press QUIT to finish.
The GPSMAP 198C Sounder’s route edit mode also allows you to
insert a new route waypoint in any route leg using the map pointer.
To insert a new waypoint between two existing route
waypoints:
1. Use the ROCKER to select the leg you want to insert the
new waypoint in (the route line is now highlighted and a
dotted line appears when the leg is selected), and press
ENTER.
2. Move the pointer to the new map location, existing
waypoint, or map item (ADD is shown below the arrow and
the route lines move with the arrow), and press ENTER.
3. If you are not inserting an existing point, press ENTER to
confirm the new waypoint.