Filter
Top Products
GPSMAP 198C Sounder Owner’s Manual 95
APPENDIX > MOUNTING THE GPSMAP 198C SOUNDER
To install the GPSMAP 198C Sounder:
1. Select a location for the mounting bracket.
2. Mark and drill the four mounting holes for the fastener you
are using.
3. Fasten the bracket to the surface using the appropriate
fastener.
4. Insert the GPSMAP 198C Sounder into the mounting
bracket. The bracket is designed for a tight fit to provide
additional support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into
the screen case.
6. Connect the power/data and antenna cables (external
antenna only) to the back of the unit, making sure the
locking rings are fully tightened on both connectors.
Flush Mounting the GPSMAP 198C Sounder
The GPSMAP 198C Sounder can be flush mounted on a flat
panel. When flush mounting the GPSMAP 198C Sounder, be sure
to choose an appropriately sized location for the unit (see unit
dimensions on page 93) and leave 1.25" (32 mm) clearance below
the data card slot for inserting or removing data cards. A Flush
Mount Template is provided in the package. Use the instructions on
the template to complete the flush mount installation.