Filter
Top Products
GPSMAP 198C Sounder Owner’s Manual 97
APPENDIX > INSTALLING THE TRANSDUCER
Transom Mount Transducer
The following diagram is for mounting the transducer included with the GPSMAP 198C Sounder with transducer package. If the
transducer lead is too short, extension cables are available from your Garmin dealer. DO NOT cut the transducer lead or any part of the
transducer cable, as this will void your warranty. The cable cannot be spliced and connected to any existing (Garmin or non-Garmin)
transducer cables.
NOTE: DO NOT mount the transducer behind strakes, struts, fittings, water intake, or discharge ports, or anything that creates air bubbles or
causes the water to become turbulent. It is important that the transducer is in clean (non-turbulent) water for optimal performance.
Do not mount transducer directly in the
path of the prop. The transducer can cause
cavitation that may degrade the boat's performance
and damage the prop.
Make sure that the transducer is
below water level when the boat
is on plane at high speed
Apply marine sealant to all
screw threads to prevent water
from seeping into the transom.
Mount the transducer cable cover
well above the waterline.
Tr
ansducer should extend 1/8" below
fiberglass hull or 3/8" below aluminum hull
OK
Mount the transducer parallel with the bottom.