Filter
Top Products
35
34
33
19
ASSEMBLY
F
L1114pr-0920
• Cut the steering wheel labels (#30, #31 and #32) from the larger
label sheet. Now, position the steering wheel labels, as shown in the
illustration, around the steering wheel.
Hint: These labels will be applied around the spokes on the steering
wheel. Carefully apply the center portion of each label to the topside of
each spoke. Gently smooth the label around each spoke.
• Remove the backing from label 30 and apply the label to the left spoke.
• Remove the backing from label 32 and apply the label to the
bottom spoke.
• Remove the backing from label 31 and apply the label to the right spoke.
Steering Wheel
Left
Spoke
Bottom
Spoke
Right
Spoke
Label 32
Label 30
Label 31
• Position the steering wheel with the large opening upright.
• Position the steering column so that the bend is upright, as shown.
• Fit the steering column through the center hole in the steering wheel.
Large Opening Upright
Steering Wheel
Steering Column
Bend
Upright
• Fit a .354 black cap nut onto the end of the steering column.
• Tap the cap nut with a hammer to secure it on the steering column.
Hints:
- You may need the help of another adult to keep these two parts in
the correct position.
- You may want to position the steering column on a scrap block of
wood to protect the assembly surface.
Steering
Column
.354 Black
Cap Nut
• With the large opening in the steering wheel upright, fit the curved
end of the steering column down into the large hole in the windshield.
• Continue to insert the curved end of the steering column through the
small, rectangular opening in the floor of the vehicle.
Curved End
of Steering
Column
Small
Rectangular
Opening
Windshield
Large Hole
36
.354"