Filter
Top Products
23
21
20
22
16
ASSEMBLY
F
L1114pr-0920
• Slide a
5
/16" large washer onto the
short end of each front axle.
• Position the steering linkage cover
over the steering linkage. Make sure
the A and B markings in the steering
linkage cover match the A and B
markings in the steering linkage. Fit
the steering linkage cover onto the front axles.
Note: The steering linkage curve should still face you.
Front
Axle
Front
Axle
Steering
Linkage
Cover
Large
Washer
Large
Washer
A Marking
A Marking
B Marking
B Marking
Steering
Linkage Curve
TOWARD You
• Fit a .437 white cap nut onto the end of a front axle.
• Tap the cap nut with a hammer to secure it to the front axle.
• Repeat this procedure to fasten another .437 white cap nut to the
other front axle.
Front
Axle
Cap
Nut
• Turn the steering assembly
over, with the smooth side up.
• Fit the steering linkage
assembly to the front end of
the vehicle.
IMPORTANT! Make sure the notch on the steering linkage assembly
aligns with the notch in the front end of the vehicle.
Notch
Steering Linkage
Assembly
(Smooth Side Up)
Notch
NotchNotch
• Insert two
1
/4" x 1
1
/4" screws through the deep holes in the steering
linkage assembly and into the vehicle.Tighten the screws.
• Pull up on the steering linkage assembly to be sure it is secure. If it is
not secure, tighten each screw a few more turns.
Deep
Holes
.437"
Steering
Linkage