Filter
Top Products
11
ASSEMBLY
F
L1114pr-0920
3
2
• Fit a round bushing, barrel side first, into the hole inside the
battery compartment.
• Position the gearbox with the teeth outward. Fit the gearbox through
the large opening in the side of the battery compartment.
Gearbox
Hole
Round
Bushing
Large
Opening
Teeth
• Fit a rectangular bushing, base end up, onto the rear axle.
• Position a hubcap, ridges down, onto the rear axle.
• Fit a lock washer, rounded side up, into the assembly tool. Make
sure it fits completely inside the assembly tool.
• Position the rear axle with the hubcap up, as shown. Fit the
assembly tool (with lock washer in it) onto one end of the rear axle.
• Tap the assembly tool with a hammer to secure the lock washer on
the end of the rear axle.
Hint: You may want to position the rear axle on a scrap block of wood
to protect the assembly surface.
• Pull on the lock washer to be sure it is secure on the rear axle.
Lock Washer
Rounded Side UP
Assembly Tool
Assembly
Tool with Lock
Washer Inside
Rear Axle
Rectangular
Bushing
Hubcap
Hole
Round
Bushing
Barrel Side
Barrel Side
Base End Up
Base End Up