Filter
Top Products
32
30
31
18
ASSEMBLY
F
L1114pr-0920
29
• Fit the notches on the inside of a front wheel traction band to the
ridges on a front wheel, as shown.
Hint: Soak the traction band in hot water for about two minutes to
soften it.
Front Wheel
Traction Band
Wheel
Ridges
Ridges
Notches
Notches
• Slide the other side of the front wheel traction band around the
front wheel.
T
M
• Turn the vehicle upright (or keep it on its side).
• Insert one of the tabs on the hubcap cover into a slot in the hubcap.
• Then, push with your fingernail (or carefully with a slotted screwdriver),
the other two hubcap cover tabs into the slots in the hubcap.
• Repeat assembly steps 27 - 31 to assemble the remaining wheel
(with round bushing and hex bushing) lock washer, front wheel
traction band, hubcap and hubcap cover.
Hubcap
Hubcap
Cover
Tab
Tab
Tab
Slots
• Place the steering wheel top face down on a flat surface.
• Fit the steering wheel bottom to the steering wheel top.
• Insert five #6 x
1
/2" screws through the steering wheel bottom and
into the steering wheel top. Tighten the screws.
Steering
Wheel
Bottom
Steering
Wheel
Top