Filter
Top Products
2
• Squeeze the tabs on the motor
harness connector to unplug it
from the battery connector.
• Squeeze the tabs on the charger
connector to plug it into the
battery connector .
• Plug the charger into a standard
120 volt wall outlet .
Note: If power to the outlet is con-
trolled by a wall switch, make sure
the switch is “ON”.
• Charge the 6 volt batteries a mini-
mum of 14 hours after each use.
Never charge the 6 volt batteries
longer than 30 hours. Overcharging
or undercharging the 6 volt batter-
ies may shorten battery life and
decrease vehicle running time.
• Once the 6 volt batteries are
charged, reconnect the battery
connector and motor harness con-
nector and lower the hood.
Note: Remember to lock the lock
fasteners to prevent children from
accessing the 6 volt batteries.
2
1
3
Charging the 6 Volt Batteries
®
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
®
®
• Rotate the lock fasteners in the
hood counter-clockwise 90º
(
1
/
4
turn) using a slotted screwdriver
to unlock the hood ( ).
• Lift the hood to access the 6 volt
batteries.
• Use pliers to remove the fuses from
the 6 volt batteries.
• Look at each fuse to make sure it
is not blown. If a fuse has blown,
replace it with a new Power Wheels
®
30 amp fuse.
• Re-insert the fuses into the 6 volt
batteries before charging. The
6 volt batteries will not charge if a
30 amp fuse in good condition is
not inserted into each 6 volt battery.
1
GOOD FUSE
"BLOWN" FUSE
®
Important Note: The 6 volt batteries must be upright while charging. You do not have to
remove the 6 volt batteries from the vehicle to charge them.
1
2
29
Battery Connector
Motor Harness
Connector