Filter
Top Products
14
Assembly
• With the light plate at an angle,
fit the notches in the light plate
around the top tabs on the inside
of a light housing.
• Lower the light plate into the
housing so that it lays flat.
• Insert a #6 x
1
/
2
" screw into the
light plate as shown.
• Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to assem-
ble the other light housing.
16
Top Tabs
Light Housing
Notches
Light Plate
#6 x
1
/
2
" Screw – 2
Shown Actual Size
13
•Using safety scissors, remove the
sport bar feet from the plastic
connector. Dispose of the plastic
connector.
• Insert the peg on a sport bar foot
into the hole closest to the back
of the seat in one side of the
vehicle body.
• Align the hole in the sport bar
foot with the hole in the vehicle
body. Make sure the large hole in
the center of the sport bar foot
faces toward the front of the
vehicle.
• Insert a #8 x 1" screw through the
hole in the sport bar foot and
into the vehicle body.
• Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to assem-
ble the remaining sport bar foot
to the other side of the vehicle
body.
#8 x 1" Screw – 2
Shown Actual Size
Center Hole
Peg
Holes
Sport
Bar Feet