HY13-1518-M1/USA
Low Speed High Torque, Hydraulic Motors
TK Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
Hydraulics
27
Torqmotor Assembly
Housing
Thrust
Washers
Seal
Shaft
Thrust
Bearing
Backup
Ring
Backup
Washer
Not To Scale
1
3
5
7
9
2
4
6
8
THE ASSEMBLY OF THE TORQMOTOR IS NOW COMPLETE EXCEPT FOR KEY (14A), NUT (14B), or OTHER
EXTERNAL HARDWARE IF APPLICABLE. PROCEED TO FINAL CHECKS SECTION.
Figure 45 Large Frame
Figure 44
Figure 43
Assemble
cover bolts
23. Assemble the 9 special bolts (1) and screw in
finger tight. Remove and replace the two
alignment studs with bolts after the other
bolts are in place. Alternately and progres-
sively tighten the bolts (SEE FIGURE 44),to
pull the end cover and other components into
place with a final torque of 44-55 ft. lbs. on
each bolt. SEE FIGURE 42 & 43.
Figure 42