Filter
Top Products
HY13-1518-M1/USA
Low Speed High Torque, Hydraulic Motors
TK Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
Hydraulics
19
Inspect housing
bearings
21. If the housing (21) assembly has passed
inspection to this point, inspect the housing
bearings (22) and (15) and since they are
captured in the housing cavity, the two thrust
washers (16) and thrust bearing (17). The
bearing rollers must be firmly retained in the
bearing cages, but must rotate and orbit
freely. All rollers and thrust washers must be
free of brinelling and corrosion.
NOTE The depth or location of bearing (15) in
relation to the housing wear plate surface
should be measured and noted before
removing the bearings. This will facilitate
the correct reassembly of new bearings.
SEE FIGURE 19.
Remove
bearings
& thrust
washers
22. If the bearings, or thrust washers must be
replaced use a suitable size bearing puller to
remove bearing (15) from housing (21)
without damaging the housing. Remove thrust
washers (16) and thrust bearing (17) and
replace. SEE FIGURES 20 & 21.
THE DISASSEMBLY OF TORQMOTOR IS NOW COMPLETE.
Figure 19
Figure 20
Figure 21
Disassembly and Inspection