HY13-1518-M1/USA
Low Speed High Torque, Hydraulic Motors
TK Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
Hydraulics
13
Disassembly and Inspection
Place
Torqmotor
in a vise
1. Place the Torqmotor in a soft jawed vice or
similar support, with coupling shaft (14)
pointed down and the vise jaws clamping
firmly on the sides of the housing (21)
mounting flange.
WARNING IF THE TORQMOTOR IS NOT FIRMLY HELD
IN THE VISE, IT COULD BE DISLODGED
DURING THE SERVICE PROCEDURES,
CAUSING INJURY.
Scribe alignment
mark
2. Scribe an alignment mark down and across
the Torqmotor components from end cover (2)
to housing (21) to facilitate reassembly
orientation where required. SEE FIGURE 2.
Remove special
bolts &
inspect bolts
3. Remove the nine special hex head bolts (1)
using a 9/16 inch size socket. SEE FIGURE
3. Inspect bolts for damaged threads. Re-
place damaged bolts. SEE FIGURE 4.
Reference Exploded Assembly View
Figure 4
Figure 3
Figure 2