HY13-1518-M1/USA
Low Speed High Torque, Hydraulic Motors
TK Series
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
Hydraulics
22
Press in dirt &
water seal
3. Press a new dirt and water seal (23) into the
housing (21) outer bearing counterbore. The
dirt and water seal (23) must be pressed in
with the lip facing out and until the seal is
flush to .020 inches (.51 mm) below the end
of housing. SEE FIGURE 28.
4. Place housing (21) assembly into a soft
jawed vise or similar support with the cou-
pling shaft bore down, clamping against the
mounting flange. SEE FIGURE 29.
Place housing
assembly
into vice
Figure 29
Figure 28
Torqmotor Assembly