Filter
Top Products
59
Configuration > Tools > Applications (Continued)
Weekly schedule:
Sunday through Saturday - Select the weekdays that should perform the
following operations:
Snapshots begin at -
Snapshots stop at - Sets the time to stop the operations.
All of the time except for
the above schedule - If you do not wish to set a schedule, this box must
be checked.
Using the DCS-5300G with an Internet
browser (continued)
Set the time to start operations. Setting the
begin time the same as the stop time will
force the operations to run continuously.
Delay second(s) before
detecting next event - Sets the time delay before restarting to check the
trigger condition when the current condition is
triggered.
Take snapshots at
second(s) after event - After a snapshot is taken because of a trigger,
another snapshot will be taken after the
configured time in seconds.
Trigger condition - There are 4 conditions related to the digital input
and three windows for motion detection. There
can be multiple selections. Select the appropriate
digital input condition according to the
characteristics of the external device. High or low
indicate external voltage input for level trigger,
while rising or falling is for edge triggers. There
are three windows shown for the names you
defined for motion detection. Undefined will
show instead of the window title if motion
detection is not setup yet. An active, named
motion window must be checked for motion
detection to be possible.
Reset output - Check and save this option to reset the external
device at the digital output back to the original
state.
Event operation: